Removing The Process Unit - Canon NP6260 Service Manual

CHAPTER 7 EXTERNALS/AUXILIARY MECHANISMS

6. Removing the Process Unit

1) Open the front door.
2) Remove the developing assembly.
(See p. 4-57.)
3) Remove the hopper assembly. (See
p. 4-62.)
4) Slide out the fixing/feeding assem-
bly, and place the drum protection
sheet on the registration roller
assembly.
5) Disconnect the four connectors
and remove the two mounting
screws .
6) Insert the drum rotating tool
the cut in the drum shaft. Fix the
drum in position so that the drum
will not rotate counterclockwise, and
insert a screwdriver into the center
hole of the drum rotating tool,
and remove the drum fixing screw.
Caution:
If you rotate the drum counter-
clockwise, the cleaning blade will
be displaced in relation to the
drum, causing cleaning faults. Be
sure to fix the drum in place before
removing the drum fixing screw.
Reference:
If you merely want to release the
hopper assembly without removing
it, open the multifeeder door and
the upper right door to allow for
space in the front.
7-18
COPYRIGHT © 1997 CANON INC.
,
into
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 7-410
Drum shaft
Figure 7-411