Starting And Stopping Components - Nortel CallPilot 703t Maintenance And Diagnostics

Using CallPilot Manager to monitor hardware

Starting and stopping components

When you stop a component, you take it out of service and prevent it
from operating. You must stop a component before you can replace it (if
the component is replaceable) or run a diagnostic test on it.
To bring an out-of-service component back into service, you must start
it.
Start and stop components from the Maintenance section on the
Maintenance screen.
ATTENTION
92
Nortel recommends that, if possible, you courtesy stop a
component. Courtesy stop is available only at the
individual channel level.
To courtesy down CallPilot, use the following:
Multimedia Monitor - to courtesy stop a range of
multimedia channels
Channel Monitor - to courtesy stop a range of call
channels:
- DS30X channels (also known as DS0 channels)
Standard 1.06
CallPilot