Avaya S8700 Maintenance Manual page 1243

DID-TRK (Direct Inward Dial Trunk)
Table 8-209. Test #6 NPE Crosstalk Test — Continued
Error Test
Code Result Description / Recommendation
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port UUCSSpp to determine the station extension,
2. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowable time period.
2100 ABORT Could not allocate the necessary system resources for this test. This could be
due to a failure to seize the port.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL This test can fail due to off-board problems, including EXP-PN and EXP-INTF
faults, TDM-BUS faults, and Tone Detectors/Tone Generators. Clear every
off-board problem before replacing the board. A TDM-BUS problem is usually
a faulty board or bent pins on the backplane.
1. Resolve any EXP-PN, EXP-INTF, TDM-BUS, TONE-BD, and TONE-PT
2. Retest the board. Replace the board if the test fails.
PASS The port is correctly using its allocated time slots. User-reported troubles on
this port should be investigated using other port tests and by examining station,
trunk, or external wiring.
0 NO The test could not relate the internal ID to the port (no board).
BOARD
1. Verify that the board's translations are correct. Translate the board if
2. Issue the busyout board command.
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board command.
555-233-143
attendant number, or trunk group/member number of the port. Enter
status station, status attendant, or status trunk to determine the service
state of the port. If the port is in use, wait until it is idle before testing.
Attendants are always in use (off-hook) if the handset is plugged in and the
port is not busied out.
errors in the error log.
necessary.
This should re-establish the linkage between the internal ID and the port.
Continued on next page
Issue 1 May 2002 8-521