Transfer Belt Right Latch Kit - Xerox Phaser 6600 Service Manual

Transfer Belt Right Latch Kit

PL6.1.98
Note: The Transfer Belt Right Latch Kit includes the Transfer Belt Right Latch Housing, Transfer Belt
Latch Spring, Transfer Belt Right Rear Spring, Transfer Belt Latch Plate, and Transfer Belt Right
Latch Arm
WARNING: The Fuser is very hot. Take added care when handling the fuser to avoid being burned.
1. Remove the Fuser Assembly. (page 4-46)
2. Remove the Waste Cartridge. (page 4-50)
3. Remove the Transfer Belt Assembly. (page 4-38)
CAUTION: When performing the following step, use caution not to drop and lose the Transfer Belt
Latch Spring (PL6.1.8).
4. Release the hook on the Transfer Belt Right Latch Arm (PL6.1.11), and pull it out of the shaft while
removing the Transfer Belt Latch Spring.
5. Release the Transfer Belt Right Rear Spring (PL6.1.9) from the Transfer Belt Latch Plate (PL6.1.10).
6. Remove the Transfer Belt Latch Plate from the shaft.
7. Remove the Transfer Belt Right Rear Spring from the shaft.
Rear
Xerox Internal Use Only
Service Parts Disassembly
Phaser 6600 and WorkCentre 6605
Service Manual
s6600-161
4-43