Xerox Phaser 6600 Service Manual page 150

Error Troubleshooting
Printer Diag
Parameter
4. Use the [ ] button to select [Life], and press the OK button.
Parameter
Life
5. Use the [ ] button to select [Trans Total PV], and press the OK button.
Life
Trans Total PV
Press the OK button to display the value.
6.
Initialize the life counter of Belt Total PV, select [Initializing], and press the OK button.
Press the Back button to return to the [Printer Diag] screen.
7.
8. Exit Service Mode. See "How to Exit Service Mode" on page 2-10.
Parameter List Print (Print)
You can print the values of the parameter of the IOT, the error count, and the life count.
CAUTIONS: When you print the parameter list, check that the Tray 1 contains A4 paper (Only A4
paper is supported). If the parameter list is printed on the paper of other than A4, some part of
the image might be lost.
• The printer will display [Processing] and suspend the parameter list from printing, if the
paper size other than A4 is set as the default paper tray setting.
• In this case, switch off the printer once, and on again, specify A4 for the paper tray
setting, enter Service Mode, and then print the list.
2-54 Phaser 6600 and WorkCentre 6605
Service Manual
Trans Total PV
21
Printer Diag
Parameter
Parameter
Regi
Life
Fuser PV
Trans Total PV
Reading
Xerox Internal Use Only