Xerox Phaser 6600 Service Manual page 94

General Information
Transmission Time
Transmission time (T
p
Resolution conversion is not performed during transmission, and density is normal.
Specified value condition: ECM (No data error)
Chart
IIEEJ No.4
ITU-T No.1
FX English Sales Text
FX Japanese Sales Text
IIEEJ No.1
a. Reference value
Protocol Control Time
When no data error occurs, protocol control time (T
V.17, V.29, V.27ter
Mode
Standard protocol
-V.34
Mode
Standard protocol
In G3 mode, when a data error that exceeds the threshold occurs, Tn increases by about 6 seconds.
In ECM (Error Correction Mode), according to the number of resending operations performed for the
occurred data error, Tn increases by about Tn+1 seconds for each resending operation.
1-82 Phaser 6600 and WorkCentre 6605
Service Manual
) of image data in G3 mode is as follows.
Super Fine
Fine
Standard
Super Fine
Fine
Standard
Standard
Standard
Standard
Before Between
messages: Tm messages: Tn
16.4 sec. or less
Before Between
messages: Tm messages: Tn
9.9 sec. or less
14.4Kbps 28.8Kbps
(MMR) (MMR)
56 sec. or less 29 sec. or less
26 sec. or less 13 sec. or less
19 sec. or less 10 sec. or less
30 sec. or less 15 sec. or less
15 sec. or less 8 sec. or less
11 sec. or less 6 sec. or less
7 sec. or less 4 sec. or less
9 sec. or less 5 sec. or less
75 sec. or less 38 sec. or less
, T , T ) is as follows.
m n u
After
messages: Tu
3.2 sec. or less 4.4 sec. or less
After
messages: Tu
1.0 sec. or less 0.9 sec. or less
33.6Kbps
a
(JBIG)
22 sec. or less
11 sec. or less
7 sec. or less
12 sec. or less
6 sec. or less
4 sec. or less
2 sec. or less
4 sec. or less
20 sec. or less
Total
24.0 sec. or less
Total
11.8 sec. or less
Xerox Internal Use Only