Xerox Phaser 6600 Service Manual page 253

WorkCentre 6605 Error Code List
Chain Link Error
077 104 RegOff JAM
077 106 Exit ON JAM
077 107 Duplex ON JAM
077 108 ExitOff ealry JAM Detect ExitOff early JAM
077 109 ExitOff JAM
077 215 IOT Duplexer
Error
077 217 Duplex Mis-
configuration
077 300 IOT Cover Front
Open
077 301 <IOT Side Cover
Open>
077 304 IOT Cover Rear
Open
077 312 Tray Configure
Error
091 400 IOT Waste Toner
Box Near Life
091 402 IOT Drum
Cartridge Kit Life
Pre Warning
091 911 IOT Waste Toner
Box Life Over
Xerox Internal Use Only
Error Details
Detect RegOff JAM
Detect Exit ON JAM
Detect Duplex ON
JAM(TBD)
Detect IOT Exit Sensor Off
JAM
Duplex Mis-configuration
FrontCover Open.
Beep sounds after
FrontCover remains open
for 3 minutes.
Side Cover is open.
Rear Cover Open
Combination of trays was
illegal.
Detect Waste Toner Box
Near Life
Detect Drum Life Warning XXXXXXXXXXXXXXXX
Detect Waste Toner Box
Life Over
Control Panel Messages
no message
no message
no message
no message
no message
Duplex Unit Error 077-215
Reseat Duplex Unit and Power
Off/On the Printer.
If this failure occurs again, please
contact customer support.
Duplexer Error 077-217
Power Off/On the Printer.
If this failure occurs again, please
contact customer support.
Front Cover Open
Close Front Cover.
Right Side Door Open
Close Right Side Door.
Rear Cover Open
Close Rear Cover.
Tray Configuration Error 077-312
Power Off/On the Printer.
If this failure occurs again, please
contact customer support.
Code:xxxxxxxxh
XXXXXXXXXXXXXXXX
Replace Waste Toner Box, Near Full
Imaging Unit Kit Near End of Life
Waste Toner Box End of Life
Open the Right Side Door.
Then, replace the Waste Toner Box.
Phaser 6600 and WorkCentre 6605
Error Troubleshooting
FIP
location
Page 2-197
Page 2-197
Page 2-198
Page 2-198
Page 2-198
-
Replace the
MCU Board.
Page 2-199
Page 2-199
Page 2-200
-
Page 2-200
Replace the
Imaging
Unit.
Page 2-200
2-157
Service Manual