Cleaning The Exterior; Cleaning The Scanner (Mfp Only) - Xerox Phaser 6600 Service Manual

Maintenance

Cleaning the Exterior

Clean the exterior of the printer once a month.
• Wipe the paper tray, output tray, control panel, and other parts with a damp, soft cloth.
• After cleaning, wipe with a dry, soft cloth.
• For stubborn stains, apply a small amount of mild detergent to the cloth and gently wipe the stain
off.
CAUTION:
Do not spray detergent directly on the printer. Liquid detergent could enter the printer
through a gap and cause problems. Never use cleaning agents other than water or mild detergent.

Cleaning the Scanner (MFP Only)

Clean the scanner as a standard part of service when anything is spilled on it, or when debris or dust
collect on any of the surfaces. Keep the feed rollers clean to ensure the best possible copies and scans.
Cleaning Procedure
1. Slightly dampen a soft, lint-free cloth with water.
2. To gain better access to the output tray, push the Control Panel Latch Release, then lift the control
panel up.
3. Remove any paper or other media from the output tray.
6-4 Phaser 6600 and WorkCentre 6605
Service Manual
Xerox Internal Use Only