Xerox Phaser 6600 Service Manual page 247

WorkCentre 6605 Error Code List
Chain Link Error
035 730 RS Request CS
NOT ON
035 737 CTC/EOR Resend
Over
035 739 T5 Time Out
035 740 ECM Send EOR-Q
Send
035 742 ECM Receive EOR-
Q Receive
035 746 Before Dial Dial
Tone
Xerox Internal Use Only
Error Details
In high-speed training,
modem CS does not
become ON against RS
request.
CTC/EOR resend over.
T5 timeout
IN ECM send, send EOR-Q. Fax Communication Error 035-
IN ECM receive, receive
EOR-Q.
Cannot detect dial tone
before dialing.
Control Panel Messages
Fax Communication Error 035-
730
High speed training error.
Job canceled. Please try again.
* Caution screen with [Close]
button
Fax Communication Error 035-
737
Continue to correct / End of
transmission resend over.
Job canceled. Please try again.
* Caution screen with [Close]
button
Fax Communication Error 035-
739
T5 Time out for Error Correction
Mode exceeded.
Job canceled. Please try again.
* Caution screen with [Close]
button
740
End of retransmission ECM error
Job canceled. Please try again.
* Caution screen with [Close]
button
Fax Communication Error 035-
742
Received ECM error
Job canceled. Remote device will
try again.
* Caution screen with [Close]
button
No Dial Tone 035-746
Please check that fax line is
connected and working
Job canceled.
* Caution screen with [Close]
button
Phaser 6600 and WorkCentre 6605
Error Troubleshooting
FIP
location
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
2-151
Service Manual