Sfp Ip Board - Xerox Phaser 6600 Service Manual

Service Parts Disassembly

SFP IP Board

(PL18.1.22)
Note: When replacing the IP Board, be sure to transfer the NVRAM and, if installed, Optional RAM,
Hard Disk or Wireless Kit to the new IP Board.
1. Remove the Control Panel Assembly. (page 4-7)
2. Remove the Front Door Assembly. (page 4-128)
3. Remove the Left Cover Assembly. (page 4-134)
4. Remove the Hard Disk and/or Wireless Kit (if installed).
5. Remove the four screws (silver, 6mm) that attach the IP Board Top Plate (PL18.1.19) to the printer
and remove the plate.
6. Remove the five screws (silver, 6mm) that attach the IP Board Bottom Plate (PL18.1.20) to the
printer (four on the side, one on the rear) and remove the plate.
Rear
4-102 Phaser 6600 and WorkCentre 6605Xerox Internal Use Only
Service Manual
s6600-188