Xerox Phaser 6600 Service Manual page 289

072-100 IOT Tray2 Misfeed JAM
072-101 IOT Path2 SNS On JAM
Step Check
Possible causative parts:
• Path Sensor [550 Option Main Feed Assembly] (PL10.2.1)
• 550 Option Regi Clutch Assembly (PL10.2.2)
• 550 Option Feed Clutch Assembly (PL10.1.8)
• 550 Option Drive Assembly (PL10.1.9)
• Feed Roller Assembly (PL10.2.3)
• Tray Retard Holder Assembly (PL10.3.3)
• C2 Size Harness Assembly (PL10.1.14)
• C2 Turn Harness Assembly (PL10.1.15)
• Feeder Motor Harness Assembly (PL10.1.16)
• 550 Option Feeder Board (PL10.1.10)
• MCU Board (PL18.1.13)
1 Check the Tray 2 installation
Is Tray 2 installed properly?
2 Check the paper path
Are there any foreign objects, or paper pieces, etc. on the
paper path?
3 Check the paper feed roller
Is the paper feed roller (the roller on the possible causative
parts list) installed properly?
4 Check the paper feed roller
Is the paper feed roller (the roller on the possible causative
parts list) deformed or worn out?
5 Check the Path Sensor operation
Execute Digital Input diagnostic test 071-117, and check the
Path Sensor operation.
Does the Path Sensor function normally?
6 Check the 550 Option Regi Clutch Assembly operation
Execute Digital Output diagnostic test 071-020, and check
the 550 Option Regi Clutch Assembly operation.
Does the 550 Option Regi Clutch Assembly function
normally?
7 Check the 550 Option Feed Clutch Assembly operation
Execute Digital Output diagnostic test 071-022, and check
the 550 Option Feed Clutch Assembly operation.
Does the 550 Option Feed Clutch Assembly function
normally?
Xerox Internal Use Only
Error Troubleshooting
Yes
Go to step 2.
Remove the
foreign objects,
or paper pieces,
etc.
Go to step 4.
Replace the
paper feed roller.
Go to step 6.
Go to step 7.
Go to step 8.
Phaser 6600 and WorkCentre 6605
Service Manual
No
Install Tray 2
properly.
Go to step 3.
Reinstall the
paper feed roller.
Go to step 5.
Refer to
page 2-213.
Refer to
page 2-214.
Refer to
page 2-216.
2-193