Xerox Phaser 6600 Service Manual page 347

3 Load the envelopes in the Bypass Tray properly.
Does this solve your problem?
4 Check the paper loaded in the paper cassette.
Remove the paper cassette, adjust the paper guides, and reload the
paper correctly.
Reinstall the paper cassette correctly, and perform a test print. Is
the image printed correctly?
5 Check the paper humidity conditioning effect.
Load the unopened (or sealed and stored under humidity control)
and recommended paper, and then perform a test print.
Is the image printed correctly?
6 Check the paper type setting.
Is the paper type setting corresponding with the paper printed?
7 Check the paper transfer path.
Are there any smears or foreign substances on the path between
the paper entrance and the paper exit?
8 Check the paper feed path roller.
Is the roller on the paper feed path not dirty, damaged, or worn,
and does it work correctly?
Also, is the roller installed correctly?
9 Check the installation status of the Transfer Roller.
Is Transfer Roller installed correctly?
10 Check the Fuser Assembly.
Is the Fuser Assembly installed correctly?
11 Check the Fuser Assembly.
WARNING:
down.
Remove the Fuser Assembly. Turn the gear by hand, and examine
the Heat Roll section.
Is the Heat Roll section not dirty or damaged, and does it work
correctly?
Xerox Internal Use Only
Action
Start the operation after the Fuser has cooled
Yes
The task is
complete.
The task is
complete.
The task is
complete.
Go to action 7.
Remove the
foreign
substance.
Go to action 9.
Go to action 10.
Go to action 11.
Contact Xerox
Technical
Support.
Phaser 6600 and WorkCentre 6605
Service Manual
Image Quality
No
Go to action 4.
Go to action 5.
Go to action 6.
Set the correct
paper type.
Go to action 8.
Clean or
replace the
corresponding
roller, and
reinstall it.
Reinstall
Transfer Roller.
Reinstall the
Fuser
Assembly.
Replace the
Fuser
Assembly.
3-21