Xerox Phaser 6600 Service Manual page 244

Error Troubleshooting
WorkCentre 6605 Error Code List
Chain Link Error
034 799 No Dial Data
035 701 Send T1 Time Out In send, T1 timeout
035 702 Receive DCN
035 704 Not Send Ability
035 705 DCS/NSS Resend
Over
2-148 Phaser 6600 and WorkCentre 6605
Service Manual
Error Details
Auto dial is activated but
no dial data exist.
DCN receive
Remote device has no
ability to send.
DCS/NSS resend over.
Control Panel Messages
Fax Number Error 034-799
No dial Data, please confirm and
enter fax number or try again.
Job canceled.
* Caution screen with [Close]
button
Target Fax is Not Answering 035-
701
T1 time out, no response detected
from remote device.
Job canceled. Confirm fax number
and contact receiving party if issue
persists.
* Caution screen with [Close]
button
Fax Communication Error 035-
702
Disconnect signal received from
remote device.
Job canceled. Remote device will
try again.
* Caution screen with [Close]
button
Fax Communication Error 035-
704
Please check remote device if error
persists.
Job canceled.
* Caution screen with [Close]
button
Fax Communication Error 035-
705
Digital Command Signal/Non-
standard Setup error.
Job canceled. Please try again.
* Caution screen with [Close]
button
FIP
location
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
Replace the
Fax Board.
Xerox Internal Use Only