Moving The Printer - Xerox Phaser 6600 Service Manual

Maintenance

Moving the Printer

WARNINGS:
• Always use at least two people to lift the printer.
• To prevent you from dropping the printer or injury, lift the printer firmly by gripping the
recessed areas on both sides of the printer. Never lift the printer by gripping any other
areas.
• If the optional 550-sheet feeder has been installed, uninstall it before moving the
printer. If the optional 550-sheet feeder is not fixed securely to the printer, it could fall to
the ground and cause injuries.
Follow these instructions when moving the printer:
1. Turn off the printer and disconnect the power cord and other cables from the back of the printer.
CAUTION: If the optional Productivity Kit (HD) is not installed, ensure that the Ready LED is off
before you turn off the printer. The data in the memory is cleared when the printer is turned off.
WARNING: To prevent electric shock, never touch the power plug with wet hands. When removing
the power cord, ensure that you pull the plug and not the cord. Pulling the cord can damage it,
which can lead to fire or electric shock.
2. Remove any paper or other media from the output tray. If the output tray extension is extended,
close it.
6-16 Phaser 6600 and WorkCentre 6605
Service Manual
Xerox Internal Use Only