Xerox Phaser 6600 Service Manual page 344

Image Quality
Bead-Carry-Out (BCO)
Bead Carryout
1 If the printer is installed in a high altitude location, set the altitude
of the location.
1. Adjust the printer for the correct altitude. See "Adjusting
Altitude" on page 6-22
Does this solve your problem?
2 Replace the Imaging Units.
Does this solve your problem?
3 Check the Development HVPS Board connector connection.
Is the Development HVPS Board connector connected correctly?
Jagged characters
nthemum x
nthemum x
Chrysanthemum x morifolium
nthemum x nthemum x
anthemum anthemum anthemum anthemum h
Fuzzy Text
1 On the Printing Options tab, set Print Quality to Enhanced.
Does this solve your problem?
2 If using a downloaded font, ensure that the font is recommended
for the printer, operating system, and the application being used.
Does this solve your problem?
3-18 Phaser 6600 and WorkCentre 6605
Service Manual
Possible causative parts
• Imaging Unit Y/M/C/K (PL8.1.2/PL8.1.3/PL8.1.4/PL8.1.5)
• Development HVPS Board (PL18.1.14)
Action
Possible causative parts
• IP Board (PL18.1.22)
Action
Yes
The task is Go to action 2.
complete.
The task is Go to action 3.
complete.
Replace the Connect the
Development connector.
HVPS Board.
Yes
The task is Go to action 2.
complete.
The task is Replace the IP
complete. Board.
Xerox Internal Use Only
No
No