Xerox Phaser 6600 Service Manual page 283

093-925 SFP / 093-953 MFP IOT X CRUM Error (K Toner)
Step Check
Possible causative parts:
• Black Toner Cartridge (PL5.1.11)
• Dispenser Assembly K (PL5.1.7)
• Top Harness Assembly (PL18.2.5)
• MCU Board (PL18.1.13)
1 Check the Toner Cartridge installation
Is the connection part between the CRUM and the Dispenser
Assembly K inside the Black Toner Cartridge clean (without
any foreign objects)?
And, is the Black Toner Cartridge installed properly?
2 Check the CRUM of the Toner Cartridge
Is the connection terminal of the CRUM inside the Black
Toner Cartridge broken?
3 Check the Dispenser Assembly K
Is the connection terminal of the Dispenser Assembly K
broken?
4 Check the Dispenser Assembly K connection
Check the connection between the Dispenser Assembly K
and the MCU Board.
Are P/J194 and P/J19 connected securely?
5 Check the continuity between the Dispenser Assembly Y and
the MCU Board
Is each cable of P/J194<=>P/J19 continuous?
093-980 IOT Y Toner Type Error
093-960 IOT X CRUM ID Error (Y Toner)
Step Check
Possible causative parts:
• Yellow Toner Cartridge (PL5.1.8)
1 Check the Toner Cartridge installation
Is a Toner Cartridge other than a Yellow Toner Cartridge
installed?
Or, is the installed Toner Cartridge for another printer?
Xerox Internal Use Only
Error Troubleshooting
Yes
Go to step 2.
Replace the Black
Toner Cartridge.
Replace the
Dispenser
Assembly K.
Go to step 5.
Replace the MCU
Board.
Yes
Install the right
Yellow Toner
Cartridge.
Phaser 6600 and WorkCentre 6605
Service Manual
No
Reinstall the
Black Toner
Cartridge.
Go to step 3.
Go to step 4.
Connect P/J194
and P/J19
securely.
Replace the Top
Harness
Assembly.
No
Reinstall the
Yellow Toner
Cartridge.
2-187