Installing Optional Memory Storage; Installing The Optional Sd Card - SATO SG112-ex Operator's Manual

2.6 Installing Optional Memory Storage

The optional SD card or USB memory can be used for uploading and downloading data (print format,
graphics, extended characters) registered in the product and printer firmware. It is not an interface for
communication.
Contact your SATO reseller or service center for the recommended SD card or USB memory.
CAUTION
Be sure to perform a virus check on the USB memory or SD card before connecting it to the product. SATO
Corporation shall not be held responsible for any product malfunctions caused by a virus spread via the USB
memory or SD card.
2.6.1

Installing the Optional SD Card

You can install an optional SD card into the SD card slot located on the rear of the product.
When using the SD card for the first time, format the SD card in the Memory mode. Refer to
4.2.7 Memory Mode for details.
1
Power off the product.
2
Insert the optional SD card into the SD
CARD slotwith the orientation the same as
shown in the picture.
Note
• Use only SATO recommended SD card. Contact your
SATO reseller for details.
• SD card: Maximum 2 GB
SDHC card: Minimum 4 GB - Maximum 32 GB
3
To seat the SD card in the SD CARD slot,
push it in until it makes a slight clicking
sound and is almost completely inside the
product.
When seated and ready to operate, only a very
small portion protrudes, approximately 3.18 mm
(0.125").
2 Installing the Product
SD CARD
SD CARD
SG112-ex Operator Manual
Section
37