No Pulse Input In Motion 3 Cutter Mode (Head Check Disabled) - SATO SG112-ex Operator's Manual

8 Appendix

8.7.12 No Pulse Input in Motion 3 Cutter Mode (Head Check Disabled)

(1) Operation
Before print
After printing the 1st label
Receive the next item after printing one label *1
Cut & Print
After printing the 2nd label
Stand-by for Eject Cut*2
Eject cut
Backfeed
*1 When the next print data is received after the first label is printed, the product prints the next data and cut the first one
when it reaches the cut position.
*2 If there is no data received after the print operation, and when the eject cut standby time is expired, eject cut is performed.
(Note)
The base position using the Gap sensor is shown above.
(2) Timing chart
Label feed
Cut
Head check
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
214
SG112-ex Operator Manual
Power ON
Print 1st
Cut Head Pitch sensor (Gap)
Print 2nd
Eject-cut standby time
Eject cut