With Pulse Input In Tear-Off Mode (Head Check Disabled) - SATO SG112-ex Operator's Manual

8.7.7

With Pulse Input in Tear-off Mode (Head Check Disabled)

(1) Operation
Stand-by
Input PRIN signal
Backfeed to the Print
base position
Feed to the manual cut
position after printing
the 1st label.
(Note)
The base position using the Gap sensor is shown above.
(2) Timing chart
Power ON
Label feed
Cut
Head check
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
*1 Retain PRIN until PREND is output.
Manual cut Head
1
Print 1st label
500ms
The amount of time before PRIN signal is received by the product.
Pitch sensor (Gap)
1
20ms
Print 2nd label
500ms
SG112-ex Operator Manual
8 Appendix
20ms
209