SATO SG112-ex Operator's Manual page 155

Comparison between single cut and multiple cut
Example 1
For PITCH POSITION= -3.00mm (-0.12") / OFFSET POSITION= 0mm
a) Single media cut
Distance between the cut
position and print position
36.2 mm (1.4")
*1. The original backfeed distance before adjustment is 39.2 mm (1.5"), however it is adjusted to 36.2 mm (1.4") in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12") from the original stop
position.
a) Multiple media cut
Distance between the cut
position and print position
36.2 mm (1.4")
*1. The original backfeed distance before adjustment is 39.2 mm (1.5"), however it is adjusted to 36.2 mm (1.4") in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12") from the original stop
position.
Cut position Base reference point for printing
36.2 mm
(1.4")
Platen roller
+3.0 mm
(+0.12")
(*1)
3.0mm
(*2)
(0.12")
Base reference
point for printing
Cut position Base reference point for printing
36.2 mm
(1.4")
Platen roller
+3.0 mm
(+0.12")
(*1)
3.0mm
(*2)
(0.12")
Base reference
point for printing
Original stop position (media will fall off).
Edit Buffer Edit Buffer
Base reference
point for printing
Original stop position (media will fall off).
Edit Buffer Edit Buffer
Non-printable area
Base reference
point for printing
5 Adjusting the Product
SG112-ex Operator Manual
153