SATO SG112-ex Operator's Manual page 120

4 Operation and Configuration
EJECT CUT MOTION
Set the Eject cut motion for the last printed media.
• DISABLE: The Eject cut motion is set to off.
• ENABLE 5 SEC - 1 SEC: The last printed media will be ejected and cut
after the set timing. The timing can be set in the range from 5 seconds
to 1 second cyclically.
Note
Shows only if PRINTER TYPE is set to PRINTER CUT.
PRINT METHOD
Set the print method.
• TRANSFER: Print using a ribbon.
• DIRECT: Print using direct thermal paper.
PITCH SENSOR
Enable or disable the pitch sensor.
• ENABLE: Enable the pitch sensor.
• DISABLE: Disable the pitch sensor.
Note
Shows only if PRINTER TYPE is set to CUTTER or CONTINUOUS.
SENSOR TYPE
Set the type of sensor for sensing the media.
• I-MARK: Use the reflective type sensor.
• GAP: Use the transmissive type sensor.
118
SG112-ex Operator Manual