Connecting The Product; Connecting The Product To A Computer - SATO SG112-ex Operator's Manual

2 Installing the Product

2.3 Connecting the Product

This section explains how to connect the product to a computer or other devices.
2.3.1

Connecting the Product to a Computer

The product supports various interfaces and can be connected to a computer in an optimum way for your
environment. When you have installed the printer driver to the computer, the data created with the
computer (documents and illustrations) can be printed to a label through easy operations.
Also, you can print by sending a command directly to the product through our All-In-One-Tool
application.
For more information about the printer driver and All-In-One Tool, please refer to the respective manual
in our SATO worldwide website (www.satoworldwide.com).
The product can be connected to a computer in the following ways.
1
Connect the Interface.
Refer to Section 2.3.2 Available Interfaces
connection.
2
Configure the interface settings.
Refer to Section 2.3.7 Interface Settings
• When you connect them with LAN interfaces, configure the communication conditions, such as the IP
address of the product.
• When you connect them with other interfaces, configure the communication conditions when needed to
adapt to the computer to which you are connecting.
• To use the printer driver, the communication protocol must be set to Status4. (The initial value for the
communication protocol for the product's interfaces is Status4.)
3
Install the Printer Driver.
You may download the printer driver and installation manual from our
(www.satoworldwide.com).
28
SG112-ex Operator Manual
for available interfaces and the references for each interface
for more details on interface settings.
SATO worldwide website