More Information About Command Error - SATO SG112-ex Operator's Manual

7.1.1

More Information about Command Error

Product motion when detecting a command error
When COMMAND ERROR is set to ENABLE in
advanced mode, the command error information is
shown on the error message (second line), and the
print operation is paused.
This error can be cleared by pressing the LINE
button, but the data in which an error is detected is
discarded and cannot be printed.
Location of error occurrence
"Caaa" in the command error message shows the
location of command error.
The number of ESC commands from ESC+A is shown in "aaa".
Note that the ESC+A command is not included in the number of ESC commands, which can be shown
up to 999. If the number of ESC commands exceeds 999, it is shown as "999".
Example)
When a command error is detected by the Horizontal Print Position <H> command
-------: [ESC]A
C001: [ESC]V100
C002: [ESC]H99999
C003: [ESC]L0202
C004: [ESC]M,ABCDEF
C005: [ESC]Q1
C006: [ESC]Z
In this case, C002 is the location of the error.
Error command name
The command name, in which an error is detected, is shown in "<bb>".
* A one-byte command name is left aligned.
Error code
The cause of command error will be indicated in the code in "cc" where an error is being shown.
Code <cc>
01 Analyzed improper command.
02 Received improper parameter.
03 Analyzed improper graphic and external character data.
04 Specified memory area (card slot) is inappropriate.
Tried to write to a write-protected media.
05 Number specified by registration command has already been taken.
06 Exceeded the registration area. (Memory full).
07 Data is not registered.
08 The specified print start position is outside the printable area.
09 The printing image is outside the printable area. (Barcode only).
=> Location of the command error
Cause
7 Troubleshooting
Command error information
SG112-ex Operator Manual
175