Rear View - SATO SG112-ex Operator's Manual

1.3.2

Rear View

1
2

Media inlet
Feed the media in this inlet.

Media guide
Adjust the media guide to the width of the
media.

SD CARD slot
To install an SD card for additional memory.
CAUTION
Be sure to perform a virus check on the SD card
before connecting it to the product. SATO
Corporation shall not be held responsible for any
product malfunctions caused by a virus spread via
SD card.

USB connector (Type B)
To connect the product to the computer using
the USB interface.

LAN connector
To connect the product to the computer using
the LAN interface.

IEEE1284 connector
To connect the product to the computer using
the IEEE1284 interface.

RS-232C connector
To connect the product to the computer using
the RS-232C serial interface.

EXT connector (External signal
interface)
Interface connector for external signals.
Connect the optional device to this terminal.

AC input terminal
Supplies power to the product through the
inserted power cord.
Before connecting, make sure that the AC
voltage of your region is in the range of AC 100
to 240 V, 50 to 60 Hz.
SG112-ex Operator Manual
1 Basic Information
3
4
5
6
7
8
9
21