No Pulse Input In Motion 3 Cutter Mode (Head Check Enabled) - SATO SG112-ex Operator's Manual

8.7.13 No Pulse Input in Motion 3 Cutter Mode (Head Check Enabled)

(1) Operation
Before Print
After printing the 1st label
Receive the next data after the first print *1
Print & Cut
After printing the 2nd label
When the eject-cut standby time is expired *2
Eject-cut
Backfeed
*1 When the next print data is received after the first label is printed, the product prints the next data and cut the first one
when it reaches the cut position.
*2 If there is no data received after the print operation, and when the eject cut standby time is expired, eject cut is performed.
(Note)
The base position using the Gap sensor is shown above.
(2) Timing chart
Power ON
Label feed
Cut
Head check
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
Cut Head
Print 1st Print 2nd
8 Appendix
Pitch sensor (Gap)
Eject-cut standby time
Eject-cut
SG112-ex Operator Manual
215