8 Appendix
8.7.14 No Backfeed and With Pulse Input in Cutter Mode
(1) Operation
Standby
Print 1st label
Cut
(2) Timing chart
Label feed
Cut
Head check(TYPE1,2)
Head check (TYPE3,4)
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
216
SG112-ex Operator Manual
Input PRIN signal
*1 No backfeed is performed in this mode, thus some area will be left non-printable
(Note)
The base position using the Gap sensor is shown above.
Power ON
*1
Print 1st
The amount of time before the product acknowledges PRIN signal.
*1 Retain PRIN until PREND is output.
Cut
Head
*1 Non-printable area
*1
20ms
Print 2nd
Pitch sensor (Gap)