Using Cutter - SATO SG112-ex Operator's Manual

3 Loading the Ribbon and Media
3
Set the media roll onto the media feeder
spindle and insert the other roll guide .
4
Place the media feeder spindle loaded
with media roll on the media feeder tray
so that it fits in the bearings.
Make sure that the print side is facing up.
5
Refer to steps 1 through 5 of
Loading Fan-fold Media
through the product.
6
After loading the media and ribbon, perform
a test print to make sure that the media is
loaded correctly.
Refer to the Section 4.2.11 Test Print Mode
details on how to perform a test print.
3.4.3

Using Cutter

When cutter is used, after setting the media, pull out
the media tray as necessary. The cut media can be
collected and stacked neatly on the tray.
Media size that can be stacked on the media
tray
Length: 40 to 117 mm (43 to 120 mm)*
1.6" to 16.5" (1.7" to 16.6")*
Width: 128 to 297 mm (131 to 300 mm)*
5.0" to 11.7" (5.2" to 11.8")*
* () is the maximum size including liner
Maximum stack height: 5 mm (0.2") (approx. 40
sheets, 0.12 mm (0.008") thick/sheet)
50
SG112-ex Operator Manual
Section 3.4.1
to load the media
for
5