Ieee 1284 Interface Connection; Rs-232C Interface Connection - SATO SG112-ex Operator's Manual

2.3.5

IEEE 1284 Interface Connection

1
Make sure that the product is powered
off.
2
Connect the IEEE1284-compliant cable
to the IEEE1284 connector of the
product.
• Use a cable that is compatible with the
standard of the interface board as stated in
Section 8.9.4 IEEE1284
orientation of the connector before you make
the connection.
3
Configure the interface settings.
Refer to Section 2.3.7 Interface Settings
more details on interface settings.
Note
• If the product is powered on without installing the printer driver, Windows' Plug & Play runs. When using the
printer driver, do not power on the product while the cable is connected, until instructed in the procedure for
installing the printer driver.
• IEEE1284-compliant: compatible mode, ECP mode, and nibble mode are supported.
• Some computers may not support ECP mode.
• ECP mode is configured in the BIOS settings of the computer. Some computers may use the software tools
for Windows.
• Some computer models may not perform ECP operations even if they are set to ECP mode. Contact the
computer manufacturer.
• Printing using the USB parallel conversion cable is not guaranteed. Also, no support for the connection
procedure is provided.
2.3.6

RS-232C Interface Connection

1
Make sure that the product is powered
off.
2
Connect the RS-232C cable to the RS-
232C connector of the product.
• Use a cable that is compatible with the
standard of the interface board as stated in
Section 8.9.3 RS-232C
orientation of the connector before you make
the connection.
3
Configure the interface settings.
Refer to Section 2.3.7 Interface Settings
more details on interface settings.
Interface. Check the
for
Interface. Check the
for
2 Installing the Product
IEEE1284
RS-232C
SG112-ex Operator Manual
31