Installing Optional Memory Storage; Installing The Optional Sd Card - SATO S84ex Operator's Manual

2 Installing the Printer

2.8 Installing Optional Memory Storage

The optional SD card or USB memory can be used for uploading and downloading data (print format,
graphics, extended characters) registered in the printer and printer firmware.
Contact your SATO reseller or service center for the recommended SD card or USB memory.
CAUTION
Be sure to perform a virus check for the USB memory or SD card before connecting it to the printer. SATO
Corporation shall not be held responsible for a malfunction of the printer caused by a virus infection through
the USB memory or SD card.
2.8.1

Installing the Optional SD Card

You can install an optional SD card into the SD card slot located on the rear of the printer.
When using the SD card for the first time, format the SD card in the memory card mode. Refer to
Section 4.2.11 Memory Mode
1
Power off the printer.
2
Insert the optional SD card into the SD
card slot with the orientation the same
as shown in the picture.
Contact your SATO reseller for the recommended
SD card.
3
To seat the SD card in the SD card slot,
push it in until it makes a slight clicking
sound and is almost completely inside the
printer.
When seated and ready to operate, only a very
small portion protrudes, approximately 3.18 mm
(0.125").
34 S84-ex/S86-ex Operator Manual
for details.
1
2