Changing Backfeed Distance - SATO SG112-ex Operator's Manual

5 Adjusting the Product
5.4.6

Changing Backfeed Distance

When you are using cutter mode, adjust the backfeed distance in consideration of the cut position
(OFFSET POSITION) and the print position (PITCH POSITION) to prevent the media being shifted away
(fall off) from the platen roller after cutting motion.
The following examples show the effect of print position and cut position on backfeed distance.
Example 1
For PITCH POSITION= -3.00mm (-0.12") / OFFSET POSITION= 0mm
*1. The original backfeed distance before adjustment is 39.2 mm (1.5"), however it is adjusted to 36.2 mm (1.4") in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12") from the original stop
position.
Example 2
For PITCH POSITION= 0mm / OFFSET POSITION= +3.00mm (+0.12")
*1. The original backfeed distance before adjustment is 39.2 mm (1.5"), however it is adjusted to 36.2 mm (1.4") in this case to prevent the
media from falling off the platen roller area.
*2. To resolve the misalignment of print due to decreased backfeed length, adjust print starting line to +3mm (+0.12") from the original stop
position.
152
SG112-ex Operator Manual
Cut position
Distance between the cut
position and print position
36.2 mm (1.4")
Platen roller
Cut position
Distance between the cut
position and print position
36.2 mm (1.4")
Platen roller
Base reference point for printing
Original stop position (media will fall off).
36.2 mm
(1.4")
*1
*2 Edit Buffer
Base reference point for printing
36.2 mm
Original stop position (media will fall off).
(1.4")
+3.0 mm
(+0.12")
*1
*2
Edit Buffer