With Pulse Input In Motion 2 Cutter Mode - SATO SG112-ex Operator's Manual

8 Appendix

8.7.16 With Pulse Input in Motion 2 Cutter Mode

(1) Operation
Standby
Backfeed
Print 1st label
Cut
(2) Timing chart
Label feed
Cut
Head check(TYPE1,2)
Head check(TYPE3,4)
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
218
SG112-ex Operator Manual
Input PRIN signal
(Note)
The base position using the Gap sensor is shown above.
Power ON
*1
Backfeed
Print 1st
The amount of time before the product acknowledges PRIN signal.
*1 Retain PRIN until PREND is output.
Cut Head Pitch sensor (Gap)
*1
20ms
Backfeed
Print 2nd