Connecting The Power Cord - SATO SG112-ex Operator's Manual

2 Installing the Product

2.4 Connecting the Power Cord

WARNING
• Do not power on or off the product, connect or disconnect the power cord while your hands are wet. Doing
so could cause an electric shock.
• Always connect the ground wire to a ground terminal. Electric shock could occur if you do not.
• Make sure that the AC voltage of your region is in the range of AC 100 - 240 V, 50 - 60 Hz. If your local
voltage is not in the stated range, contact your SATO reseller or technical support center.
CAUTION
The attached power cord is designed exclusively for this product. Do not use it with other devices.
1
Connect the power cord to the AC input
terminal at the rear of the product.
Take note of the orientation of the connector.
Secure the product with one hand, and insert the
connector tightly.
2
Insert the power plug into an AC outlet.
*The shape of power plug varies depending on
the region.
Note
This product is also designed for IT power distribution
system with phase-to-phase voltage 230 V.
34
SG112-ex Operator Manual
1