With Pulse Input In Tear-Off Mode (Head Check Enabled) - SATO SG112-ex Operator's Manual

8 Appendix
8.7.8

With Pulse Input in Tear-off Mode (Head Check Enabled)

(1) Operation
Stand-by
Backfeed to the Print
base position
Feed to the manual cut
position after printing
the 1st label.
(Note)
(2) Timing chart
Label feed
Cut
Head check (TYPE1,2)
Head check (TYPE3,4)
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
210
SG112-ex Operator Manual
Manual cut
Input PRIN signal
The base position using the Gap sensor is shown above.
Power ON
*1
Print 1st label
500ms
The amount of time before the product acknowledges PRIN signal.
*1 Retain PRIN until PREND is output.
Head Pitch sensor (Gap)
*1
20ms 20ms
Print 2nd label
500ms