No Backfeed/Pulse Input In Cutter Mode - SATO SG112-ex Operator's Manual

8.7.9

No Backfeed/Pulse Input in Cutter Mode

(1) Operation
Stand-by
Print 1st label
Cut
Print 2 label
Cut
*1 Take note that there are some non-printable areas, as no backfeed is performed.
(Note)
The base position using the Gap sensor is shown above.
(2) Timing chart
Power ON
Label feed
Cut
Head check
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
Print 1st label Print 2nd label
Cut Print head
*1 Non-printable area
SG112-ex Operator Manual
8 Appendix
Pitch sensor (Gap)
211