No Pulse Input In Tear-Off Mode (Head Check Enabled) - SATO SG112-ex Operator's Manual

8 Appendix
8.7.6

No Pulse Input in Tear-off Mode (Head Check Enabled)

(1) Operation
Stand-by
Backfeed to the Print Base position
Print 1st label
Print 2nd label
*1 The time specified by <TW> lapses.
Feed to the
manual cut position
(2) Timing chart
Label feed
Cut
Head check
Ext. signal
PRIN
PREND(TYPE1)
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Operation
208
SG112-ex Operator Manual
*1 The media is fed to the manual cut position when time (option unit stand-by time; default value -
1000ms) specified by <TW> lapses and no print job is sent.
(Note)
The base position using the Gap sensor is shown above.
Power ON
Backfeed
Print 1st label
500ms
Manual Cut Head
Feed
Print 2nd label
Time specified by <TW>.
Pitch Sensor (Gap)