Dipsw; What You Get; No. Setting - SATO DR300 Quick Manual

DR300 Quick Guide

What You Get

The DR300 printer comes packed in a protective carton.
Included in the carton are the following items:
•
DR300 Printer
•
Quick Guide
•
Driver / Manual CD-Rom
•
2-Pin Power Cable or 3-Pin Plug
•
Head Cleaning Sheet
•
Sample Ribbons
•
Ribbon Take-up Core
•
Cleaning Solution
•
Cleaning Cloth
•
Ribbon Part List
•
Maintenance Contract
After taking the DR300 Printer out from the carton and
removing the protective plastic cover, it is ready for
installation.
Installation and Handling Instruction
Place of installation
•
Place on level surface
•
Avoid vibration
•
Avoid high temperature and humidity
•
Avoid high environment
Power Supply
•
AC220/240V power supply is needed
•
Supply electricity from main power supply
•
Three pin earthed power lead is required
•
A maximum of 3 amp fuse link is recommended
DR300 Quick Guide
Pg 2
DIP-Switch Setting
DIP-Switch Setting
DIP Switch shall be set when printer is off.
Each DIPSW setting is described below.
*All are set to OFF position as factory defaults.
No. Setting
1 ON
OFF
2 Separate
3 Sheet 1
4 ON
OFF
5 Separate
6 Sheet 2
7 Separate
8 Sheet 3
Separate sheet 1 (Parity setting)
2 3
ON ON
ON OFF
OFF ON
OFF OFF
Separate sheet 2 (Baud rate setting)
5 6
ON ON
ON OFF
OFF ON
OFF OFF
Content
Data bit No. = 7
Data bit No. = 8
Parity setting (None, Even, Odd)
Stop bit = 2
Stop bit = 1
Baud rate setting (2400, 4800, 9600, 19200)
Protocol setting (Ready/Busy, Xon-Xoff, Status-3)
Content
(Reserved)
Odd
Even
None
Content
2400 bps
4800 bps
19200 bps
9600 bps
Pg 31