Device Address And Device Name; Reading The Area, Line And Device Address - Siemens Synco 700 Series Basic Documentation

Introduction
Start page:
Selecting the main menu
Note
Main menu
Note
Path to the "Basic
settings" page
Device information
Building Technologies
HVAC Products
4

Device address and device name

4.1 RM... controllers
The RMZ790 and RMZ791 operator units are identical for the purpose of access to
the RM... controllers and in terms of their application and functions.
The RMZ792 bus operator unit, which has the same mechanical design as the
RMZ791, is used for remote access to the Synco 700 bus devices and in terms of
application and functions it differs substantially from the RMZ790 and RMZ791
operator units.
4.1.1

Reading the area, line and device address

The area, line and device address are factory-set in the RM... controllers. The
settings can be read with the RMZ790 and RMZ791 operator units at the Service
level (indicated by the
From the start page, press the OK knob for access to the "Main menu" (see
illustration below).
Wednesday 28.05.2003
Welcome
« Information
Main menu »
On delivery from the factory, the start page displays the word "Welcome" instead of
the device name.
Main menu
Time/date...
Faults...
Settings
Device information
The bottom of an operating page is indicated by the "Arrow Up" symbol. For access
to the top of the page, the knob is rotated counter-clockwise.
The path for access to the "Basic settings" page containing the factory-set
addresses is as follows:
Main menu > Device information > Communication > Basic settings
Device information
Controller...
Extra configuration
Communication...
Basic documentation: Communication via the KNX bus
Device address and device name
symbol).
15:06
29/120
CE1P3127en
30.08.2007