Setting leaf media
Unlike roll media, leaf media does not need to be fixed with the roll holders.
• To prevent the rigid media being jammed into the Y bar, raise the head in advance.
(
Turn the clamp lever to the front.
1
Set the leaf media.
2
• When [DIRECT] is set on the media feed setup (
sensor that is on the platen (below the pinch roller on the right edge).
Hold the media with the media retainer
3
gently.
2-16
Downloaded From ManualsPrinter.com Manuals
P.2-24)
• From the back of this machine, insert the media
between the pinch rollers and the platen.
• From the front, set the media not to get out of the
right end pinch roller.
• When using a thick media, remove the media
retainer from the media before drawing.
Clamp lever
Pinch roller
P.3-12), set the media on the media
Pinch roller
Media retainer