Cleaning The Cap Absorber - MIMAKI Tx300P-1800 Operation Manual

Wiper cleaner
• If there is a large amount of ink in the absorbent case,
wipe it away using water-absorbent paper or the like.
• Do not remove the wiper cleaner from the bracket.
• Only clean the front surface on the wiper cleaner's
wiper. (You do not need to clean the rear surface.)
• Do not remove the absorbent material in the
absorbent case.
• After the wiper cleaner cleaning, make sure that
the cleaner is not facing up.
OK
Set the wiper at the original position.
7
• Insert the wiper by holding the protrusions at its
both ends.
Protrusion
Clean the cap rubber.
8
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
Wipe off so that maintenance solution for
maintenance will not remain.
• After cleaning the cap rubber, check to make sure
the cap slider is not tilted.
If it is tilted, move the slider block left and right to
fix its tilt.
Press the
9
Close the front cover then press the
10
• After its initial operation, the machine returns to
NG
step 1.

Cleaning the Cap Absorber

It is recommended that the wiper and cap be cleaned
frequently in order to maintain the high image quality of
the machine and keep the machine itself in good working
order.
Press
1
• MAINTENANCE MENU will be displayed.
Press the
2
• The carriage moves onto the platen.
Chapter 4 Maintenance
Cap rubber
Slider block
Cap slider
key after the cleaning.
key.
(MENU)
in LOCAL.
key twice.
1
2
2
4
5
Carriage
6
4-11