Setting Leaf Media - MIMAKI JV400-LX Series Operation Manual

Setting leaf media

Unlike roll media, leaf media does not need to be retained with the roll holders.
1
Open the front cover.
2
Raise the clamp lever.
3
Insert the leaf media between the platen and the
pinch rollers.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• Set the media so that the media end does not reach the slot
of the post-heater.
4
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
• Close the drying heater cover.
2-14
• Set the media on the black part of the
platen so that it comes out approximately
40mm. If it is shorter than that, it may not
be able to perform the media detection.
Media
Clamp lever
Approximately
40mm
Front cover
Pinch roller
Media press