If A Waste Ink Tank Confirmation Message Appears; Replace The Waste Ink Tank With Another - MIMAKI Tx300P-1800 Operation Manual

Projection
• For the twin wiper
Projection
Close the front cover, and press the
8
key.
• After its initial operation, the machine returns to
LOCAL.
If a Waste Ink Tank Confirmation
Message Appears
Ink used in head cleaning, etc. is stored in the waste ink
tank on the lower right side of the machine. This machine
counts the accumulated amount of discharged ink. When
that reaches a specified amount, the machine displays a
confirmation message. (When this message is displayed,
consider the replacement of the waste ink tank.)
• The message is displayed when it reaches 80%
(1.6L ) of the 2L tank on the lower right side of the
machine.
• The waste ink tank on the left does not
cumulatively count the amount of discharge of
such a substance as ink. Even if the level of dirty
water in the tank becomes 80% or over, no
message appears.
Check the level of dirty water in the tank on the left
often and dispose of dirty water if pooled.
Confirmation Message in LOCAL
The warning message "Check waste ink"
1
is displayed.
Check the state of the waste ink tank
2
• For any difference between the displayed level
and the actual level of discharge amount, carry
out the operations described in and after step 3.
• If there is no difference between the displayed
level and the actual level, and if you replace
(dispose of) the waste ink tank, carry out the
procedure described in "Replace the waste ink
tank with another" (
Press
(MENU)
3
in LOCAL.
• MAINTENANCE MENU will be displayed.
P.4-23)
Press to select "REPLACE
4
WasteInkTank", and press the
key.
If the amount of waste ink needs to be
5
adjusted, press the
Press to adjust the level, and
6
press .
Press the
7

Replace the waste ink tank with another

When the waste ink tank becomes full, carry out the
procedure below to replace the waste ink tank, and in the
Maintenance menu, set 0% for waste ink tank information.
If you replace the waste ink tank before the waste ink tank
confirmation message is displayed (before the 2L tank is
80% (1.6L) full), carry out the same procedure to replace
the waste ink tank.
Press
(MENU)
1
in LOCAL.
• MAINTENANCE MENU will be displayed.
Press to select "REPLACE
2
WasteInkTank", and press the
key.
• Waste ink tank information is displayed.
Press to adjust the level, and
3
press the
Press the
4
• The waste ink tank amount that is managed in this
machine will be reset.
Pull the waste ink tank stopper to open to
5
the front.
Waste ink tank
stopper
Pull it frontward to remove by holding the
6
waste ink tank handle.
Chapter 4 Maintenance
key.
key.
key.
key.
4-23
1
2
2
4
5
6