Washing The Head Nozzle - MIMAKI Tx300P-1800 Operation Manual

Chapter 4 Maintenance
Open the front cover.
3
Cleaning Cap absorber.
4
• Wipe off the ink adhering to the cap absorber with
a clean stick or nonwoven towel dipped in the
maintenance cleaning solution.
• Wipe off so that maintenance solution for
maintenance will not remain.
Cap absorber.
Press the
5
Close the front cover then press the
6
key.
After its initial operation, the machine returns to step 1.

Washing the Head Nozzle

Press
1
in LOCAL.
• MAINTENANCE MENU will be displayed.
Press
2
• "STATION" will be selected.
Press
3
WASH", and press the
Press
4
head, and press the
When "WIPER CLEANING" appears on the
5
display, open the front cover.
Clean the wiper and the bracket, and press
6
the
(1) Open the right maintenance cover then pull
out it by holding protrusions at both ends of
the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
protrusions at both ends of the wiper.
4-12
key after the cleaning.
(MENU)
.
to select "NOZZLE
key.
to select the washing
key.
key.
• After cleaning the wiper, check to make sure the
cap slider is not tilted.
If it is tilted, move the slider block left and right to
fix its tilt.
Cap slider
When cleaning of the cap rubber is
7
complete, close the front cover and press
the key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
Fill up the cap with cleaning solution for
8
maintenance．
• If the cleaning solution cartridge is usable,
maintenance solution is automatically filled.
• When the cap is filled with cleaning solution, the
display will prompt you to check the cleaning
solution.
• If the front cover is not closed, the cleaning
solution will not be automatically filled. If the front
cover is open, be sure to close it.
Protrusion
Slider block