Setting Leaf Media - MIMAKI JV300-130 A Operation Manual

Close the front cover.
12
Press the key to select "ROLL" .
13
• Detects the media width.
• When [MEDIA RESIDUAL] of the maintenance
function is "ON" (
entering media remaining amount is displayed
after detecting the media width.(
Entering the media remaining amount
When [MEDIA RESIDUAL] of the maintenance function is
"ON" ( P.3-13 ), the screen for entering media
remaining amount is displayed after detecting the media
width.
Display the screen for entering media
1
remaining amount.
Press
2
remaining amount.
Press the
3
About the media residual print
When [MEDIA RESIDUAL] of the maintenance function is
"ON" ( P.3-13), You can print a list of print the current
date and media remaining.
In Local, Press
1
• It enters into the origin setting mode.
Press the
2
• Appear the confirmation
remaining print.
Press the
3
• Media residual print starts.
Front cover
P.3-13), the screen for
P.2-7)
to enter the media
key.
.
key.
screen of media
key.
Chapter 2 Basic Operation

Setting leaf media

Unlike roll media, leaf media does not need to be retained
with the roll holders.
Open the front cover, and raise the clamp
1
lever.
Front cover
Insert the leaf media between the platen
2
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
Pinch roller
Hold the media with the media press
3
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
Media press
Clamp lever
2
2
2
5
6
2-7