Setting Interval Wiping; Setting External Heater - MIMAKI Tx300P-1800 Operation Manual

: When the set number of prints has
FILE
been completed, the machine
performs head cleaning
automatically.
LENGTH : When the set length has passed, the
machine performs head cleaning
automatically.
: When the set time has passed, the
TIME
machine performs head cleaning
automatically.
• If you have selected "DEFAULT", proceed to Step 8.
Press , and press
6
select the cleaning interval.
• Depending on the auto cleaning type selected in
the Step 3, the setting value differs.
: 1 to 1000 file
For FILE
For LENGTH : 0.1 to 100.0 m (in 0.1 m
increment)
: 10 to 480 min (in 10 min
For TIME
increment)
Press the
7
to select the cleaning type.
• Set Value : NORMAL/ SOFT/HARD
Press the
8
to select "Cleaning Check".
Press the
9
to select set value.
• Set Value : ON/ OFF
• If you have selected "FILE" st step 5, proceed to
Step 12.
Press the
10
to select "EXEC.TIMING".
Press the
11
to select set value.
• There are "END OF FILE" and "PRINTING" for set
values.
END OF FILE : Carries out the cleaning
operations between files after the
cleaning interval configured
under "LENGTH" or "TIME" in
Step 6 has passed.
: Stops printing and starts the
PRINTING
cleaning operation immediately
after the cleaning interval
configured under "LENGTH" or
"TIME" in Step 6 has passed.
Press the
12
Press the
13
end the setting.
• Depending on the state of the heads, etc., the image
quality deterioration may not be improved even with
this function performed.In this case, contact our
service office or the distributor in your region.
L
to
key, and press
key, and press
key, and press
key, and press
key, and press
key .
key several times to

Setting Interval wiping

When the set time has passed, nozzle face of the head is
cleaned automatically to remove ink droplets on the
nozzle face.
In case that deflection, nozzle missing, or symptom which
ink droplets fall down occurred, set the interval between
each operation shorter.
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (<<) .
3
Press to select "INTERVAL
4
WIPING", and press the
Press to set intervals.
5
• Set Value : 3 to 255 Minutes, OFF
• When [OFF] is set, periodical wiping is not
executed.
Press the
6
Press the
7
end the setting.

Setting External heater

Used to set external heater to ON/OFF.
Press
(MENU)
1
Press to select SETUP 1 to 4,
2
and press the
• SETUP MENU will be displayed.
Press (<<) .
3
Press to select "EXTERNAL
4
HEATER", and press the
Press to select set value.
5
• Set Value: ON/OFF
Press the
6
Press the
7
end the setting.
Chapter 3 Setup
in LOCAL.
key.
key.
key.
key several times to
in LOCAL.
key.
key.
key.
key several times to
3-11
1
2
3
4
5
6