Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
Set the FEEDING UNIT and TAKE-UP UNIT
1
to "OFF" in "Setting Feeding and Take-up
unit" of the machine setup.(
Open the front cover, and then raise the
2
clamp lever.
Front cover
Insert the leaf media between the platen
3
and the pinch rollers, and push down the
clamp lever.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
Pinch roller
Hold the media with the fabric retainer
4
gently.
• Set the media so that it does not extend to the
right of the V-groove on the platen.
• When using a thick media, remove the fabric
retainer from the media before printing.
In this case, set the machine setup of "Setting the
Media Detection" to "MANUAL" (
refer to P.2-15 "Setting of the manual media width
setting" and set the media width.
fabric retainer
Close the front cover.
5
• Set the media straight.
P.2-4)
Press
6
The media detection is started.
7
(1) The media width is detected.
(2) The media is fed then the rear end of media
(3) It returns to the Local when the detection is
P.3-15), and
Chapter 2 Basic Operation
• For the leaf media, use only a withy one.
When using the leaf media, the take-up device is
invalid. If the set media is not withy, the printing
face will not become flat and the media will jam.
• Set media long enough to cover tension roller.
Otherwise, the media may be caught between
tension roller and the fabric roller and get jammed.
to select "LEAF" .
is detected.
completed.
2
2
2
5
6
2-21