Cleaning The Fabric Retainer / Media Press; Cleaning Of Grit Roller - MIMAKI Tx300P-1800 Operation Manual

Chapter 4 Maintenance
Cleaning the Fabric Retainer /
Media press
When you wish to clean dirt such as ink etc. adhered on
the fabric retainer, you can remove the fabric retainer to
clean it.
• Replace the fabric retainers and media presses
with new ones if they are deformed or damaged.
4-6
Media press

Cleaning of grit roller

Remove pre-treatment agent or lint adhering to the grit
roller with the resin brush periodically.
• Clean the grit roller periodically.
• In some cases and depending on media pre-
treatment agent, if it is left on the grit roller, it may
cause rust.
• If rust is generated on the grit roller, there is the
fear that it cannot feed the media normally.
Turn the power switch OFF.
1
• Tilt the power switch to the "O" side.
[END/POWER]
key
Open the front cover and raise the clamp
2
lever.
Wipe the surface of the grit roller with the
3
brush to remove blot.
• Wipe the surface of the grit roller for several times
lightly.
• Brush the circumference of the grit roller while
rotating the right side of it with your fingers.
• Wipe off dirty edge of the brush with a dry cloth.
• If the dirt is hard to remove, try putting some water
on the brush.
• Be sure to clean the grit roller with resin
brush. If you wipe off with a fabric or a
paper, lint may adhere to concavity and
convexity parts. In addition, if you use a
hard metallic brush etc., it may scratch the
grit roller.
• After brushing using water, feed some
unnecessary media to remove any
moisture.
The right side of the grit roller
Main power
switch