Table of Contents
Advertisement
Setting leaf media
Unlike roll media, leaf media does not need to be retained with the roll holders.
1
Open the front cover.
2
Raise the clamp lever.
3
Insert the leaf media between the platen and the
pinch rollers.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• Set the media so that the media end does not reach the slot of
the post-heater.
4
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from the
media before printing.
5
Push down the clamp lever.
• Set the media straight.
6
Close the front cover.
2-26
Downloaded From ManualsPrinter.com Manuals
Front cover
Clamp lever
Pinch roller
Media press
Advertisement
Table of Contents
