Setting Leaf Media; Removing The Taken-Up Media - MIMAKI SWJ-320EA Operation Manual

Setting leaf media

Unlike roll media, leaf media does not need to be retained
with the roll holders.
Open the front cover and raise the clamp
1
lever.
Front cover
Insert the leaf media between the platen
2
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
Hold the media with the media press
3
gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
2-16
4
Clamp lever
5
6
7

Removing the taken-up media

1
2
Media Press
Push down the clamp lever and close the
front cover.
• Set the media straight.
Press the key.
Press the key to select "LEAF" .
• If the [Setting the Display of Media Detection] of
Machine Setup set in "AUTO"(
machine automatically detects the media width.
Setting the Logical Seek.
(1) Press [][] to select the set value.
• Set value : Media/ Data/ Quality
(2) Press the [ENTER] key.
• When [Media Remain] of the Machine Setup
is "ON" ( P.3-14), you are prompted to
enter the media remaining amount. (
9)
Release the lock of the taking-up tension
bar and lower the tension bar.
Open the cover on the left side of the
taking-up shaft and pull the taking-up shaft
forward.
P.3-15), the
P.2-
Lock