Chapter 1 Before Use
Limited media
With the following media, correction from the plotter is difficult.
When using any of the following media, perform test printing to determine whether it can be used or not.
• High stretch fabric (Stretch materials, vertically extendable knit, etc.)
• Materials which become largely extendable when getting wet by printing.
• Materials with large width variations.
• Materials which present partial wrinkles of slacks when being spread on a flat surface or materials which are totally curved.
• Materials with large take-up shift at the ends of media when rolled.
• Roll media with a paper tube whose strength is insufficient and which bends when attached to a feeding unit.
• Even when using media other than described above, be sure to print by optional test data. After checking the printing
result, judge whether it can be used or not.
Fabric conditions which enable to print
Items
Width variation
Curve when expanded
Slack height when expanded
on a flat surface
Displacement of roll edge
Inner diameter of roll
Fabric core strength
Fixation with fabric core
Roll outer diameter
Roll weight
Print side
Fabric wrinkle
1-16
Condition
less than 5 mm / one side edge
One-direction curve not allowed
2 mm or less
15 mm,
Cloth (width of 500 mm and less) is 2 mm.
2 to 3 inches
Roll bend of 5 mm or less when set.
Fix with the tape three point or more or weak adhesion.
250mm or less
40 kg or less
Not specified
Not allowed
Remarks