Rear Side And Right Side Of The Machine - MIMAKI Tx300P-1800 Operation Manual

Chapter 1 Before Use

Rear Side and Right Side of the Machine

The following figure shows the Tx300P-1800 MkII. It differs slightly from the Tx300P-1800.
Roll holders
Putting this into the paper core (right and left) of a roll
media, hold the media. It supports the paper core of 2
inch and 3 inch.
1-4
Clamp lever (rear)
Interlocks with the clamp lever
in the font of this machine.
Feeding tension bar
Adjusts the media tension on the feeding side.
USB 2.0 connector
This is USB2.0 interface connector.
LAN connector
This is Ethernet interface connector.
Main power switch
Turns on/off the main power for this machine. Leave
the main power turned on to prevent ink clogging.
AC inlet
Connect the power cable to the AC inlet.
Top blower
Suppress upward
floating of the ink mist
that occurs during
printing.
Feeding folding bar
Stabilizes the media
tension on the feeding
side.
Waste ink tank
Waste ink gathers in this tank.
Feeding device
This device feeds media
forward in the direction of the
front of the machine.